• Measuring, Analysing, Storing
Search Menu

Data Sets

The option Data Sets enables the division of a single measurement into several partial results, so-called data sets. The change of a data set can be triggered by an external digital signal or by means of the Terminal Programme. The data sets are saved either on …

Read more

Automatic Data Transfer

The ADT software is a stand-alone software package that performs the data transfer from MATCH or MICRO Recorder to a PC. The programme is started from the command line. All special functions (e.g. Start, Stop, Clear, etc.) are controlled by command line parameters. Thus, the basic …

Read more


The n-adjust-all function allows the simultaneous offset adjustment of several or all analogue channels. The function is helpful in simplifying the procedure of channel adjustment when offsets for several channels need to be repeatedly adjusted within short time periods.


Damage Calculation (based on Rainflow matrices) The Damage Calculator is an addition to the MAS Terminal Programme for the subsequent (offline) damage calculation based on recorded Rainflow matrices. The result is the damage value which allows for the evaluation of the charged load cycles as to …

Read more

Export to Diadem

This option allows the export of the following software to Diadem: RF – Rainflow  (incl. Level Crossing und Range Pair) TM – Transient Mode TaL – Time at Level SQTMS – Sequential Peaks and Troughs with Time and Master/Slave concept DE – Damage Evolution